2003 Land Rover Freelander "new water pump bolt" Questions

...NEW WATER PUMP.CLEAN COOLANT PUMP AND MATING FACE OF CYLINDER BLOCK.LUBRICATE NEW O RING WITH RUBBER GREASE,AND FIT TO COOLANT PUMP.FIT COOLANT PUMP TO CYLINDER BLOCK .FIT NEW BOLTS TIGHTEN IN ...

...new water pump, the seal between the water pump back plate to the timing gear housing would not seal. I used new gasket and water pump sealer. there are 4 bolts that hold the water pump back plate to ...

...new water pump, install new water pump gasket, position new pump onto engine, install water pump bolts and tighten evenly in a pattern from the most center bolt positions out ward around the water ...

...new water pump gasket and the water pump onto the cylinder block. Tighten the retaining bolts to 12-15 ft. lbs. (16-20 Nm). Reinstall the timing belt and the timing belt covers as outlined in this ...

new water pump with a new gasket, tightening the bolts to 89 inch pounds (10 Nm). Reinstall the drive belt and the battery with the battery tray. Refill the engine's cooling system with coolant. Start

...new gasket, install water pump to engine as follows: Guide water pump nipple into bypass hose as pump is being installed. Install water pump bolts Tighten water pump mounting bolts to 40 N·m (30 ft. ...

...new gasket and water pump in place, install all the bolts. 9) Reinstall the PS pump and torque bolts. 10) Install pulley on water pump and torque. 11) Install serpentine belt. 12) Re-torque bolts on ...

...new gasket and water pump in place, install all the bolts. 9) Reinstall the PS pump and torque bolts. 10) Install pulley on water pump and torque. 11) Install serpentine belt. 12) Re-torque bolts on ...

new gasket on the water pump using gasket adhesive. Place the water pump in position on the engine with the pulley and four retaining bolts loosely installed on the hub. Apply pipe sealant to bolt No.

...NEW water pump O-ring seal. Important: A guide pin can be created to aid in water pump alignment. Use a M 6 m x 6 mm stud. Thread the pin into the water pump sprocket.Using the guide pin, align the ...