2000 Land Rover Range Rover "pedel working" Questions

...working. I change all bulbs even though the one in place were good. I have checked the switch to the break pedel and it completes the circuit to ground when the pedel is depressed (is this correct or ...

...won't go on unless I press the petal all the way. SOUNDS LIKE A SWITCH PROBLEM ITS UP HIGH ON BREAK PEDEL UNDER THE DASH BOARD TRY UNPLUGING WIRES AND CLEANING CONTACTS AND YOU COULD SRRAYING CONTACT ...

working Ckeck your brake switch its located on the top of the brake pedel. Alot of times there is an adjust ment up there where a plunger will hit on a stop this plunger ativates the switch its like a

...working at the same time Check the switch, located on the brake pedel the stop light switch and the cruise control switch are on the brake pedel towards firewall. The cruise control switch is

...pedel switch must be working or you would have no brake lights . I would advice to check the cruise control switch first its linked to the brake pedel switch . Also look for other electrical problems ...

...working. Next take the jumper leads connect them to the terminals on the brake switch one to each side of the switch clip the other ends to the leads from the meter set the meter to OHMS.There should ...

...come out of park & no brake light The problem you have is probably the button above the brake pedel is stuck in. This button ativates the brake light and will allow the car to come out of park ...

both brake lights are not working. check blubs if ok go to fuse box check fuse if that's fine also go to brake pedel there is a switch that is mounted to pedel make sure its working

my breakes dont work till they are almost to the floor Try pumping the brake pedel. If the pedel travel comes up, the rear brakes need to be adjusted. If the pedel does not come up, it could be a bad ...

neither brake light is working first check all of your fuses. if the fuses are all good then make sure the brake switch at the brake pedel is working