ac torque specs for a 2006 kia optima? 1.5L and 1.6L engines: * Installation is the reverse of the removal procedure. Tighten the compressor mounting bolts to 17-26 ft. lbs. (24-36 Nm). 1.8L engine: *
...AC compressor bolts Oil pan bolts Oil pan Fig. Remove/Install the oil pan bolts in this sequence-2.2L (VIN F) engine To install: Apply a 2 mm bead of RTV sealant around the perimeter of the oil pan ...
...AC COMPRESSOR AND BRACKET .REMOVE CRANKSHAFT PULLEY REMOVE OIL PAN REMOVE OIL PUMP SCREEN AND THE TUBE REMOVE FRONT COVER REMOVE TIMING CHAINS REMOVE CRANKSHAFT TIMING GEARS REMOVE OIL PUMP.WHEN ...
...compressor mounting bracket over water pump stud and secure to cylinder head with four bolts tightened to 54-71 Nm (40-53 ft. lbs.) and secure nut to water pump to 41-54 Nm (30-40 ft. lbs.). -Install ...
...ac compressor out of the way remove it and the PS pump from the block, then unbolt the exhaust manifold and unbolt the two bolts that secure the oil pan to the exhaust downpipe, remove the starter, ...
...AC compressor from the block so you won't loose the freon . Disconnect all the wire harness connections on the engine sensors. Take off the radiator fan and the radiator Remove the fuel lines Remove ...
...AC compressor without letting the freon out. Same goes for the power steering pump. Disconnect both radiator hoses. It's a good idea to remove the hood to give clearance for the engine hoist. ...
AC compressor if necessary) Remove small belt guard just above water pump (on 3.1L) Remove water pump mounting bolts (around the perimeter of the pump- approximately 5 of them) and remove the pump. If
...AC compressor. You will also have to pullout the Plastic snap things with needle nose pliers so get the plastic covers away from you work area ( I didn?t remove ALL of the plastic completely, just ...
512 questions posted
Usually answered in minutes!
974 Questions
370 Questions
337 Questions
285 Questions
277 Questions