...socket, in two or three steps. Clean the gasket pieces from the cylinder block top surface and cylinder bottom surface. Cylinder head and related components Cylinder head bolt torque sequence To ...
...need a 3/8 drive ratchet and extension with a spark plug socket. A flex universal is always a handy thing to have and may help you in the tight spots. Remember these are aluminum heads so don't over ...
...The coil-packs are held with two 10mm bolts each and are difficult to get to. Use universal-joint sockets and an extension. Takes about 2.5 hours to R/R spark plugs. The average do it
socket you are using will need some modification. If you look in the socket you will see that there is a small lead in relief and this will only allow the socket to full engage on 1/2 of the bolt head
Question about Kia Sorento
...need a 6 point universal socket with extension you need high impact air ratchet that give enough torque to remove bolts in hard tight spots.for round off bolt head go to sears or go on line you can ...
need to remove, if possible, the housing along with alternator to break the bolt If there's enough room for a socket - try an impact socket on the rounded off bolt. An impact socket can be hammered on
Socket set and ratchetStep 1: Remove the timing cover. The timing cover will need to be removed to gain access to the timing belt or chain. This is necessary because the cam shaft sits in the cylinder
Question about Kia Sorento
...need a 17mm or so socket hex key or a socket that fits the hex head on the bolt. You should get a new axle bolt with the new CV joint..I prefer the socket head cap screw type because the socket hex ...
socket goes on the bolt is stripped. need to remove? My thermostat housing is cracked on my 1996 police interceptor, I did not realize this until i installed the new o ring gasket with the thermostat.
...socket and wrench) could be used as the access panel is very small. What do I need to use to remove the torque convertor bolts? This is just a shot in the dark, but maybe try a 5/8" or 11/16" or 3/4" ...
1,367 questions posted
Usually answered in minutes!
780 Questions
590 Questions
514 Questions
148 Questions
163 Questions