2006 Hyundai Santa Fe "replacing lower ball joint 94" Questions

lower ball joint. will i damage seal? I am replacing axle but not ball joint. I will use ball joint removal tool That's the right way and only way to do this, just put some lube on the fork side, that

...lower ball joints on a 94 chevy suburban YOU NEED SOME TOOLS LIKE 1/8 1/2 DRILL BITS.YOU NEED A PUNCH.YOU NEED A BALL JOINT SEPERATOR.YOU NEED BALL JOINT PRESS TOOL TO PRESS OUT BALL JOINT AND PRESS ...

...Lower Ball Joints replacing on Mitsubishi car? http://howtobyme.blogspot.in/2012/02/lower-ball-joints-replacing-on.html--------This will help.Thanks. You SHOULD NOT have to replace your ball joints ...

lower ball joint in 94 lincoln markviii they are riveted in place, it is much easier to replace the control arm (comes with ball joint installed already).n You can drill it out, and install a threaded

...LOWER BALL JOINTS Raise and support the front end on jackstands. Support the lower control arm with a floor jack. Remove the wheel. Remove the lower stud cotter pin and loosen, but do not remove, the ...

...lower ball joints -upper ball joints -inner tie rod ends -outer tie rod ends -idler arm -pitman arm -center link -stabilizer links -stabilizer bars It is not likely that all of those need to be ...

...lower ball joint , the OEM ball joint is riveted on with three rivets, the replacement is bolted on with three bolts/nuts. Carefully drill out these rivets (try not to elongate the mounting holes) . ...

lower ball joint. 4. You can first try hitting the side of the ball joint with a hammer and if it doesn't pop it loose you will have to use a Pickle fork. If you have to use a pickle fork and the ball

...lower ball joints, wheel bearings hub kind rotors and brakes. Anyone know or have this happen to them? You need to replace the upper control arm bushings and upper ball joint on both sides as well. ...

...lower ball joint arm has alot of spring tension, how do I get it down enough in order to get the ball joint connected back to the hub? is there a trick to this, can I loosen another part to make this ...