...SHAFT SENSOR LOCATED The 2002 Santa Fe came with three (3) possible powertrains (engines). The 4 cylinder, and two different V6 engines - i.e. 2.4L 4 cylinder, the 2.7L V6 and the 3.5L V6. The ...
...responsible for sending a signal to the PCM (powertrain control module) it tells the computer what cylinder to fire at the coresponding time, it lines up with whats called a trigger wheel on the ...
2001 hyundai santa fe 6 cylinder 2.7 spark plug wiring position from spark plug to ignition coil. 3 coils have the numbers 1-4 2-5 3-6. so what number goes to whst spark plug? HI...... OK. just follow
Question about Hyundai Santa Fe
...run 180 degrees outta time? Hard to start but runs moves. Very unlikely. Everything works from cylinder number 1 being at TDC on firing stroke. Crankshaft position sensor and Camshaft position ...
...this at least 3 times before stays running. Could this be a coil pack issue? It's called a "dead" cylinder and you did right by replacing the cam sensor. Still does it though? Do a ohm meter test
Question about Hyundai Santa Fe
crank shaft position sensor on a 2007 hyundai santa fe 3.3 cant find location located on the bell housing of the transmission under left cylinder head or radiator side of engine
...cam is doing, though, you might want to check it thoroughly. Also, just getting compression in one cylinder is not a verification of whether the cam is turning. There are bound to be more than one ...
location of crank position sensor 2003 santa fe 4 cylinder hi the sensor is in with the timing belt. You will have to remove the timing belt cover and belt to put a new one in. You will also see a ...
...and pcm with a crankshaft position signal. the module uses this signal to determine spark for each cylinder. the pcm uses this signal for proper timing of engine. Could be fuel starvation, possibly ...
392 questions posted
Usually answered in minutes!
1,503 Questions
1,043 Questions
1,001 Questions
881 Questions
417 Questions