2003 Hyundai Tiburon "remove lower ball joints 03" Questions

...lower ball joints on a 03 f350 4x4? You can rent the tool that pressess the ball joints out at the auto parts store. Looking at the new ones, Remove the lock rings from the old ones remove the ...

...Remove the lower ball joint from the front wheel spindle using U-Joint Tool T74P-4635-C and Receiver Cup D81T-3010-A5 or equivalent for F-150. Use Ball Joint Remover T94T-3010-AH for F-250 and F-350. ...

...Remove the lower ball joint from the knuckle. Remove the axle hub snap ring from the knuckle. Remove the axle hub from the hub bearing using special tool 09520-00031 or equivalent hub puller. Remove ...

...lower arm ball joint nut. Remove the front suspension lower arm ball joint from the front wheel knuckle. Remove and discard the cotter pin. Remove the tie rod end nut. Use Tie Rod End Separator ...

...Lower ball joint. Just using the jack will force the A-Arm up, until it puts pressure against the ball joint. When the car starts to lift up, STOP! Bring it down just a little. You want your vehicle ...

...remove the 3 lower ball joint fasteners, outer tie rods, and for someone who has not done these before, remove the struts bolts, but be sure to mark the spindle so it can go back exactly or you will ...

...lower suspension arm and steering knuckle slightly to facilitate easier halfshaft removal. Remove the 2 disc caliper mounting bolts, then lift the front disc caliper off of the front disc brake ...

...lower control arms on my 03' Escape last night, it took about 1.5 hours/side. A second set of hands is helpful. The only difficulty was the pass. side ball joint bolt and nut were seized and ...

...lower ball joint loose and remove the axle nut and push the axle out of the knuckle and tie the knuckle up out of the way then you can take a pry bar and pry the axle out of the transmission being ...

...Remove the two bolts attaching the strut to the steering knuckle. NOTE Use caution when separating the ball joint stud from the steering knuckle, so the ball joint seal does not get cut. Separate the ...