2002 Hyundai Accent "engine stalling problems" Questions

engine stalling on a 2002 chevy tahoe z71 the engine stalls about every 10-15 minutes but starts back up fine The engine stall at low speed and engine cut while shifting gear ,seen low pressure on the

...engine light is staying on but when the car starts missing and stalling badly, the light blinks. when it stops blinking (stays on), the engine pickups power and will run "OK" for a littlw ...

...carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake ...

...stalling after timing belt replacement I recently did the 60,000 mile tune up on my 2008 accent. Changed timing belt and spark plugs ect. About a week afterwards the engine begins to mildly stall ...

may lose its power again, or maybe not. Not a clutch problem. Engine isn't stalling. Fuel filter has been changed. Please Help ! ! ! hmm sounds like fuel pump and fuel sending unit inside the gas tank

stalling This problem is likely caused by a dirty automatic idle speed control valve and throttle blade valve, follow the procedure for cleaning them Buy a can of throttle valve cleaner (it is made by

...Wait 15 - 20 minutes and try again and then it WILL restart. Very intermittent. No MIL / check engine light. Car runs and idles well otherwise. Have replaced front O2 sensor (had check engine ...

...(this is not ABSOLUTE). Possible causes are numerous (fuel pump pressure, ignition, air flow, engine cylinder compression, etc., etc., BEST SOLUTION: Take/tow the vehicle into a Hyundai Service ...

engine stalling Hi. my accent 2004 petrol is giving me a problem last couple of days. The engine will stall every now and then. this is not happening continuously. Seems to occur after driving ...

...2001 Hyundai Accent 1.5 L, stalls out at stop signs and red lights. No codes are present, and check engine light does not come on, any ideas? Fuel pump? See if your idle air control valve needs to be ...