1994 Geo Metro "not power" Questions

...power. Can not drive it. The code is P0505 idle control malfunction. I checked the fuel pressure and its ok. Whats next? Idle control, only controls idle, it will not cause no power, and that code ...

...not getting power check for a blown fuse. If you are getting power check for a blown bulb or bad socket. Now if you are not getting brake lights and you are calling that tail lights then the issue ...

...NOT GETTING ENOUGH POWER. WHAT COULD THAT BE?storm wont turn CAR RUNS BUT SEEMS TO NOT BE GETTING ENOUGH POWER. WILL BARELY PULL A HILL. check for bad ignition wires and plugs. a black line on the ...

...not sure on that but also check the power steering fluid level Good idea to check the power steering if the car had power steering. Zerk (grease) fittings are not installed at the factory on any ...

...to the neg or ground. Yellow should have power (battery voltage) when you hit parking or headlights if I'm correct. If not may be the power antenna wire if it's from the radio, not used in most

...power, check is fuel pressure, if not at spec, say at 10psi (low) then there will be no power. if the engine you have has a MAF sensor and is dead, that will cause limphome and low power. the first ...

...not communitate with the car, even my neigbor used a hand OBD-II diag computer and there was no power at all to get a reading or a code. I used a fuse tester to see if any power in the diag connector ...

...not getting power to the pump. I checked the conections and there good, so I jumped out the relay and the pump is not getting power. 1998 chevy metro lsi 4 cylynder. it will run for a minute if I ...

...power and does not move . check the operation of the clutch. > if auto run fault codes and check for torque converter clutch servo or faulty TCM unit . If manual check clutch cable is working ...

...switch put a jumper wire on it and the commpressor would not come on what do think it is is there power at one side ? if yes then compressor is shot, if no power on either side then electrical ...