clutch pedal. If there is fluid dripping from the Master you will need to replace the unit. If not look at the clutch slave cylinder which attaches to the bell housing. This unit has the same internal
...cluster. Losen the locknut on clutch master cyl. pushrod and turn pushrod in or out to get specified stroke and height at clutch pedal. The pedal stroke should be 5.6" and the height should be
...clutch pedal, ...
...clutch pedal free play is 0.35 to 0.59 thousandths. (About 11/32nds to almost 19/32 of an inch) 9 to 15mm. This is the free play measurement of the clutch master cylinder piston, to the pushrod ...
...clutch pedal You adjust the pedal height by turning the clutch master cylinder pushrod which is attached to the clutch pedal under the dash. Loosen the locknut and turn the rod to raise or lower the ...
...clutch pedal to I cant disconnect the pushrod from the clutch pedal to remove master cylinder on a 2000 silverado 4.3l 5 speed. I feel a plastic clip but it has 4 places to push in and makes no sense ...
...clutch pedal there is a weezing type sound as the pushrod slides into the sleeve in the fire wall. Am I missing a bushing or need to replace the whole line from pedal to tranny? please help. did you ...
...CLUTCH PEDAL QUICKLY.HOLD IT DOWN.HAVE A HELPER TIGHTEN THE BLEED SCREW.ALLOW PEDAL TO RETURN SLOWLY.BLEEDER SCREW TORQUE IS 5 - 6 FT LBS.IF YOU SEE AIR BUBBLES CLEAR BLEED TUBE.REPEAT THE BLEED ...
get in gear clutch has been replaced You may need to adjust the clutch pedal free-play. There is usually an adjustment behind the pedal bracket on the pushrod that goes into the clutch master cylinder
...clutch pedal. If you get a couple wrenches and unlock the clutch master pushrod adjuster nuts and effectively lengthen the pushrod, you can probably get a little more life out of the clutch you have ...
167 questions posted
Usually answered in minutes!
284 Questions
121 Questions
119 Questions
74 Questions
70 Questions