...Jeep Enthusiast Forums that provides the tightening sequence for the 3.8L upper intake plenum of a 2007 Chrysler TWC. Here are the steps: Remove covering on lower intake manifold and clean ...
...4.0 liter jeep engine is probably one of the best engines ever built. Just never ever run one hot. Almost the only thing that can kill one. Ok start by looking at all the intake and exhaust manifold ...
Question about Saturn SL
...intake manifold has internal EGR. REMOVAL (1) Disconnect the negative cable from the battery. (2) Drain the cooling system (refer to Group 7, Cooling System for the proper procedures). (3) Remove the ...
Question about Cars & Trucks
...jeep wrangler 2.4 connecting rods ENGINE 2.4L DESCRIPTION N·m Ft. Lbs. In. Lbs. Balance Shaft Carrier to Block-Bolts 54 40 - Balance Shaft Gear Cover-Double Ended Fastener 12 - 105 Balance Shaft ...
Question about Jeep Cars & Trucks
...jeep liberty 2.4l 4 cyclinder engine. The intake manifold is blocking bolts and cannot see the best way to remove it. https://ibb.co/ww9Xtvj Click on the link. My database showed this procedure. Good ...
...jeep wrangler 4.2 I also have an '89 Wrangler with a 4.2 liter inline six. I'm afraid that the spark plugs aren't on the same side as the manifolds. Mine is being a pain in the *** for me. The intake ...
...jeep Cherokee 4 wheel drive, 2.5 L 4 cylinder engine. I need to take the carb off to tighten it up. I touched it and the RPM went up and down because the carb is loose. Try checking underneath the ...
...4" in diameter) The rectangular box is where the air filter is located, the engine end is connected to the throttle body. The throttle body is bolted to the intake manifold. All of that assembly can ...
...only to the cylinder head gasket. Do not allow sealing compound to enter the cylinder bore. What is the torque specs for the intake and exhaust manifold for a 1997 Jeep Cherokee Sport? 6.. ...
...jeep Crankshaft Position (CKP) Sensor . . . 4 cyl motor . . . where is it? No not the motor . . .the CKP! Thanks NOTE: The crankshaft position (CKP) sensor is mounted to the transmission bellhousing ...
1,795 questions posted
Usually answered in minutes!
953 Questions
963 Questions
862 Questions
606 Questions
85 Questions