2002 Land Rover Freelander "home hub 4 replace 2" Questions

Ad

Question about Land Rover Freelander

1 Answer

home and pulled it back to 2 wheel drive and parked it. The next morning I went and put it back into 4 low and had no front movement or traction. SO I tryed 4 high and still nothing. I have been under

Ad

Question about Land Rover Freelander

2 Answers

...hub face. Reverse procedure to install. If the rear bolts don't come out then you will have to use a slide hammer to separate the bearing to replace the rotor and there is a very good chance you will ...

Ad

Question about Land Rover Freelander

1 Answer

...hub using the 18 MM box wrench. 11) push back the brake claiper piston to its home position and install the inner brake pad (the one with the snap clips) 12) insert the outer brake pad in the claper ...

Question about Land Rover Freelander

1 Answer

...HOME  REPAIR INFO  1999 LEXUS ES300 3.0L SFI DOHC 6CYL REPAIR GUIDE SUSPENSION REAR SUSPENSION COIL SPRING REAR SUSPENSIONLexus Car ES, IS, LS 1998-06Coil Spring Rear ...

Question about Land Rover Freelander

2 Answers

...home the trans stuck in 5th gear and would not dis-engage. The cluth slave cylinder is full of fluid. I recently had a new cluth installed and the slave cylinder was replaced too. The slave cylinder ...

...hub assembly from the vehicle in order to replace the bearing, which is fairly straightforward, apart from the usual corroded nuts and bolts considering the age of the vehicle. The big problem is the ...

Question about Land Rover Freelander

2 Answers

...hub to there, make sure the car is out of gear or this will be very difficult :) 8 once the stud is in take something you can use as a spacer like a larger then the stud nut. for example and then put ...

Question about Land Rover Freelander

1 Answer

...home did some research and ended up taking off my right wheel to check the speed sensor well i could see bare wires. Ordered a new hub and still cant go over 25 mph before the rpms just rev up and ...

...hub bearing or track rod end being worn, but for it to be worn on both sides then this would have to mean either the tracking is out on both sides or both bearings are bad, which is not very likely, ...

Question about Land Rover Freelander

1 Answer

...hub to there, make sure the car is out of gear or this will be very difficult :) 8 once the stud is in take something you can use as a spacer like a larger then the stud nut. for example and then put ...

Not finding what you are looking for?
2002 Land Rover Freelander Logo

1,319 questions posted

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...