Question about Kia Sorento
how many camshaft and crankshaft sensors does my 2004 KIA Sorento have? The camshaft position sensor is mounted on the engine near the camshaft gear by the ignition coils.The crankshaft position ...
...the 4 bolts and water pump pulley. 9.Remove the 4 bolts and timing belt upper cover 10.Turn the crankshaft pulley, and align its groove with timing mark "T" of the timing belt cover. Check that ...
...starts fine, belts don't move Hi, it sounds like your harmonic balancer has separated from the crankshaft pulley. There is a rubber cylinder between the pulley and core that bolts to the ...
where is the crankshaft sensor fitted on a kia 2.5diesel 2006 where is the crankshaft sensor fitted Check and see if it is just behind or to the side of the Harmonic balancer
crankshaft position sensor 2004 kia sorento hope you get this diagram if not go to autozone library when you open the hood go to middle of the front of engine it should be very close to the crankshaft
...if you give just a little throttle when cranking starts There could be a few reasons why your car's crankshaft may not be turning at the correct speed. One possibility is that the engine may not be ...
...turns over but no ignition - no power to instrument panel This sounds like it could be a faulty crankshaft position sensor. One thing you can do is go to a part place and either rent (autozone ...
...down the road it shuts off. When it cools off, it will crank again. It has a v 6 engine. Your crankshaft sensor could be bad. There has been a recall for your model, take it to your local kia ...
replace crankshaft sensor Under crankshaft pulley.
2004 Kia 3.5 crankshaft bolt and pulley parts update? if there is parts update for crankshaft bolt and pulley. Or a service bulletin for the crankshaft bolt It is a BOLT, it takes a lot of Force ...
949 questions posted
Usually answered in minutes!
787 Questions
780 Questions
590 Questions
148 Questions
163 Questions