1994 Geo Prizm "replacing cv axle half shaft" Questions

...CV axle or entire drive axle? on this type of vehichle, you have two axles in the front; one going to each side. Chances are that the boot at the axle joint was torn and that is why you are having ...

Axle Vibration 2003 Chevrolet Malibu LS I had a bad Hub on the drivers side so I replaced the Hubs on both sides as well as the CV Half Shafts. After the repair I now have a severe vibration at speeds

axle shaft for seal wear. Ensure that the shaft is not bent. If you do not want to remove the front transaxle (pumpkin) or drop it, then replace the HALF shafts by removing them at the inner CV joint

...2000 Ford Windstar. I would buy a rebuilt axle half shaft from your parts store and replace. It is cheaper than CV, boot. grease, and seal And, you have new CV's on each end of axle half shaft, not

...by a torn CV joint boot. Your only option is to replace the axle shaft (also called a half shaft). It is recommended that axle shaft seal be replaced at the same time you replace the axle

...CV Axle on a Ford Escape / Mazda ... ? 9:41 https://www.youtube.com/watch?v=_JxagNLBlQ4 Aug 29, 2013 - Uploaded by klowny1969 Axle nut should be torqued to spec..in the ford escape its around 205-220 ...

...cv axle in 2001 ford escort 4 cylinder Replace cv axle remove wheel on side. remove brake caliper/brakes, disconnect lower ball joint, remove axle shaft hub nut. push axle out of hub, then pull half ...

...axle shaft with both CV joints at each end inspected and reconditioned with new grease and CV boots installed. You need to know which side is bad before buying.  The half-shaft is sold ready to ...

...that you will have to replace. install new half shaft and re assemble in reverse order. the axle nut torque is 135 lbs. its cheaper to replace the half shaft as a unit as opposed to just the cv

CV joint on the half shaft. The only special tool needed is the axle nut socket. support the vehicle, remove the wheel, remove the axle nut, remove the lower ball joint, separate the lower control arm