...fuel injector check? TBI 8v engine is 1 ohm MPI 16v has 4, injectors, and all read the same 10 ohms. there are lots of test. ohms presssure flow and leak down test. and a balance test ...
Question about Geo Tracker
...fuel injector ohms be reading or the voltage should be reading. i checked mine 4 of them are reading in the 20s voltage what should the ohms be reading or the voltage should be reading Ohms should ...
Question about Geo Tracker
...you can ohm check the injectors by disconnecting each one and touching the pins inside the connector cavity on each injector. The ohm reading should read between 5-20 ohms. I hope this info
...ohm scale check number 2 fuel injector should be 11 to 16 ohms if not reads zero fuel injector faulty.if numbe 2 fuel injector okay.use noid light hook it to fuel injector electrical connector ...
Question about Cars & Trucks
...ohm reading. On the plug end you should have a jumping reading, when cranking the engine, set it to dc volts.. It never gets to 0 volts or 12 volts, Just jumps between them. If you have no voltage ...
Question about Cars & Trucks
...fuel injectors to make sure they are good on a 1987 z28 one wire has battery voltage when the key is on and the other wire at the injector is ground circuit which is controlled by the ECM and pulses ...
Question about Geo Tracker
...each probe to either terminal on the injector. A normal ohm reading would range from 11.8 -12.9 ohms. Any reading from 1.0 to 8.0 or 15.0 and higher, the injector is no good and should be
...fuel injector is bad Check the resistance across the injector terminals with an ohm meter. The resistance should be pretty low, a few ohms, but all manufacturers have their own specifications. Check ...
Question about Geo Tracker
...enough. it can flood or not be enough fuel at cold starts. once started , the ECT must go to 300 ohms at 180F water temp if not the ECU things ,its cold started and it floods and has horrid power.
fuel pressure at spec. injector coil reads 1.0 OHMS. injector clean. (there is only one, so all hope is just here) noid lamp fails , so is CMP dead? or TPS TP pin stuck high or , ecu throwing code 41.
228 questions posted
Usually answered in minutes!
350 Questions
228 Questions
207 Questions
187 Questions
169 Questions