2005 Jaguar X-Type "oil put hammer drill" Questions

put on the harmonic balancer You will have to use an "easy out" . You first drill a hole into the bolt. The get an "easy out" and hammer it in to the hole that you drilled. Turn conterclockwise. There

...drop to the ground instead on into the engine. After the old tube has been drilled out. tap the new one into the engine block with a rubber hammer. Put the pan back on, fill with oil and you're

put pressure on the rotor to pushit of hub if not use large hammer and hit the face of rotor between studs to loosen it up also dont be afraid to use lots of wd40 of so sort of penatrating oil on them

...oil change plug is froze. I tried BP blaster an it still didn't work. Any other methods to get the plug off. Try hitting the plug a few times with a hammer and then put the socket on and hit the ...

...oil, contaminants must be removed before the weld is made. I mean ALL the contaminants! Then, with a drill motor and a wire brush scrub it thoroughly. blow it off with compressed air and wash it with ...

...hammer and a screwdriver or b ig nail with a sharp point.. poke a hole in the tank and drain the fuel out into the bottles our drain pan..BUT..NO SMOKING...NO OPEN FLAME..NO LIGHTERS etc..this gas is ...

put some of the old oil back in to wash out any swarf ] replace new plug with new gasket washer but dont over tighten when replacing . THE other way is to tap it with a screwdriver and hammer but only

...put just a little bit of force to one side in order to slightly bind the bit, and usually it will hang on to the bolt and back it out. Good luck and I hope this helps. spray with penetrating oil let ...

...put pressure on the rotor to push it of hub if not use large hammer and hit the face of rotor between studs to loosen it up also don't be afraid to use lots of wd40 of so sort of penetrating oil on ...