2006 Suzuki Forenza "frame" Questions

...of the front passenger door is made of? dwon side? the lower part, is steel, the door has shell frame, its cold rolled punch pressed steel. the covers inside are

...for each side...all are 10mm. Two bolts are on top of the assembly, attaching it to the top of the frame/radiator support. The third nut is on the bottom and to the left (if drivers side) or the ...

...not open replacing the hood latch cable. I do not know how it is routed. I know it goes through the frame under the hood, behind the quarter panel, then into the cabin area. Problem is, the cable ...

...above malfunction condition in two consecutive drive cycles. ? PENDING CODE is available. ? FREEZE FRAME DATA is available. ? AT warning light illuminates. ? DTC is stored in TCM memory. POSSIBLE ...

...be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support. You will have vertical adjustment screws for each independent ...

...a battery of test. sure. hope that helps, post all stored, DTC,all pending and the full freeze frame data and if cagey? the closed loop status hot idle. just remove the batt for 15 mins and ...

door frame cracking why? crackin frame It is unibody stress cracking it happens after force from bumps or accidents twisting of the vehicle frame or old age

...is a bit easier--you only need a deep socket 10mm to remove the nut holding the assembly to the frame or if you don't have a deep socket, remove the fill tube for the winshield washer, then

...change? There are (2) three and a half inch long jack pads on both sides of your vehicle along the frame rail located exactly twelve inches behind each of your front wheel assemblies. You can place ...

...bottom mounting bolt on alternator for 2005 forenza The bottom mounting bolt buts up against the frame and will not slide out far enough to remove the alternator. Is there a trick to getting it