Question about Mercury Sable
...EGR backpressure transducer hoses and need to be replaced with the same type to reduce the risk of fire also you may need a new sensor as some of the newer ones are plastic and melt with the hoses ...
...egr feedback sensor ends and hoses to melt down on a 2002 ford mecury sable? a bad egr valve that's letting combustion gasses backflow into the sensor. YOU MAY HAVE HIGH ENGINE EXHAUST TEMP. YOU ...
...to two metal tubes which run to the exhaust. Now what sets the the P1405 is. While driving, the EGR monitor commands the EGR valve closed and checks the differential pressure across the EGR ...
...egr pressure feedback sensor keeps melting on the smaller vacuum side. And keeps blowing out smaller hose. Engine is running ok at idle but will not accelerate past 20 mph. What would cause this to ...
Question about Mercury Sable
...hose off or plugged.. aaECM detected EGR flow in a negative direction with aan Probable cause: Failed DPFE sensor(EGR pressure sensor). Open or shorted circuit condition.. plugged or damaged EGR tube ...
...shudder. to check the egr locate and squezze up from the bottom this should cause the shudder. if not trace the vaccum hose back to the solenoide. if no vaccum leaks i would check the solenoide
...the engine more on passenger side. It is a combo valve with pressure sensor which is a round plastic part attached with hoses to the egr valve. It was common for those to melt and cause egr
caused by a bad EGR valve and vaccum selonoid and or a bad DPFE sensor and blocked or melted hoses going to the DPFE.I usally remove the EGR Valve and using a hand held vaccum pump ck the Valve to see
...EGR vacuum solenoid come off? The old vacuum solenoid got melted from the bottom. I replaced it and now the Rport hose comes off the vacuum solenoid. I have poor acceleration going uphill and when I ...
977 questions posted
Usually answered in minutes!
689 Questions
646 Questions
540 Questions
534 Questions
383 Questions