2006 Jeep Liberty "car hesitate 2nd 3rd gear" Questions

...2nd or 3rd gear. There is also a hesitation in the mornings when I shift it from reverse to drive. Welcome to the current world of computer controls. Unless it never did this for a couple years your ...

...transmission when it shifts from 2nd to 3rd gear it hesitates then will go to 3rd gear not a smooth transition. sounds like the symptom of a bad clutch, might need adjustment at local repair

...the 3rd and 2nd gear and reverse? any solutions? it hesitates whele gear is on drive and loses it speeds that i had to switch gear on 3rd ,what seems to be the problem? Time for a rebuildTrans is ...

2nd-3rd. Why are you shifting from 2nd to 3rd gear ? is this a standard or automatic? If its a automatic its normal for the torque converter to catch up with the speeds of the tranny. To save the life

...car is excellerated a hard sift or jerking/hesitation motion occures somewhere between 1st and 2nd or 2nd and 3rd gears if we press the gass very lightly and proceed with a very slow pace the problem ...

...2nd and 3rd at about 2300 rpm each time. Then the rpms will just keep going up and the car will not accelerate any more. Then at about 3800rpm, it will downshift as though i'm trying to pass. What ...

...2nd to 3rd gear. no other problems indicated. check fluid levels and condition of fluid, look for contaminants in it, change fluid and filter if anything is seen in the fluid..also check detent cable ...

...2nd and 3rd gear when shifting 1 time and then its fine im guessing manual trans? fuel line issue. pumps, filter or possibly injectors or your clutch gears are slowly on the brink of no longer ...

...1st to 2nd=18 to 22 mph 2nd to 3rd=28 to 32mph 3rd to od=48 to 50mph these all change by how much throttle pressure is being use, are you sure it's not fuel filter or plugs and wire surge your ...

...2nd and 3rd shifts fine what could be the problem. a number of issues. Tcc regulator bore worn out, the infamous check ball seat it hammered badly, or/and calibration issues. I have seen all three ...