gauges still light up and the turn signal and high beam indicator stay on. I have check the switch , could it be in the multi function stalk ie turn signal lever? The lights will work fine one day and
AC blows cool then turns warm and stays warm for awhile. Needs to be recharged. hey, I added some freon to mine. Works for now, but refrigerant pressure is going down each week, which means I have a ...
...the car, let it warm up (it's fully warmed when it reached 210 on the thermostat/temp gauge) and I turned the heat on to floor/vent. Cold Air. I turned it off, back on same thing. Slowly checked
...to 12V constant supply. This retains memory. Red will go to switched (ignition) 12Vsupply. this turns it on and off with the car. Black is ground. It is a light wire typically. this lets the ...
...turn over dash powered UUP but fuel gauge dead and low fuel indicator lit. any ideas what makes you think it has one? 1st check all fuses in both boxes then make sure CEL glows, key on, NO CEL means ...
...turn the engine off then back on, the gas gauge goes back to full but the check engine lights stays for the next 10-15 cranks. Then the check engine light goes away. After that no more problems until ...
...the security light came on. The jeep kept running for about 30 seconds then just died after stoping turned the ignition off then restarted it everything came back on but the check engine light stayed ...
...stays on check your ignition switch, they have a mechanism where if the transmission is on any gear ( including neutral ) it wont turn over all the way back, so if you turned off hte vehicle and got ...
...with. Any ideas on what to try? THANKS check fuel filter,listen to see if fuel pump cycles when you turn the key on,shuld run for 3 seconds,sounds like fuel pressure ...
375 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions