Question about Honda Accord
how much torque i need to use to tighten the intake manifold on a 2005 honda accord aproximatly 20 foot LBs
2000 honda accord v-6 intake manifold torque spec 22 nm
intake manifold.Remove the engine ground cable from the cylinder head or valve cover.Relieve the fuel pressure using the proper procedure. Disconnect the fuel lines.Disconnect the accelerator cable at
...intake manifold and throttle body/carburetor. Connect the throttle control cable and/or accelerator cable at the throttle body. Connect the fuel lines. Install the brake booster, PCV and charcoal ...
...intake manifold (in the middle, under one nut) Detach the fuel lines (already did left one; detach the pressure line at the right end of the fuel rail). Remove the mounting nuts (four) and detach the ...
intake torque specs on a 2.4 honda 2004 torque specs intake manifold double posted, see alldata.com look it up , self.
Question about Honda Accord
is there a torque spec for the plenum nuts going on the intake manifold studs? on 1991 honda accord 2.2 l there is a gasket in between plenum and intake manifold. 14 in/lb
04 honda 2.4 intake torque spec i need the torque specs for the intake manifold intake to head? its in the FSM and at alldata.com log in and read. like us. $15 subs.. dirt cheap.
... nut shell? (generic) Cold engine. 1: battery neg lug off 1st then PLUS lug last (in that order) 2: intake and exh, manifolds removed or retracted. 3: valve cover off, 4: drain coolant. 5: drop cam ...
...intake manifold gasket and the throttle body gasket. The fuel is metered in by how much air the computer knows is going past the mass air flow sensor or the MAP sensor. If extra air gets sucked in ...
2,046 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions