Question about Chrysler Pacifica
...engine light on & code # 300 & 420. also, manifold tuning valve (MTV) solenoid makes thicking noise when key on & off. if cat is the problem, it's cover by warranty? now 99k miles.... ...
Question about Chrysler Pacifica
...engine off and the key on, do you mean normal as 40-50 psi, or normal, as 0 psi since the engine was off and there should be no oil pressure? This is important because if you are reading 40-50 psi ...
...key on but engine not running the gauge goes to center, the old normal running position. With the engine running it is almost full scle high. With sending units at $50 I haven't run out to buy one. ...
Question about Chrysler Pacifica
...key is on but engine NOT running gauge moves to center position, roughly same point it used to go to when operating normally. With engine running gauge reads almost full scale high. Is it gauge, ...
Engine 3800 for 98 Park ave. shows oil pressure too high on the gauge. what could cause this Sounds like your oil pressure sending unit is faulty! When you turn the key on, is the gauge reading low, ...
Question about Chrysler Pacifica
...Engine Error Codes Cycle Key on-off-on-off-on to read codes in odometer display P0002 ECM fuel calibration error P0016 Crankshaft/Camshaft Timing Misalignment/Out-of- Sync P0071 Ambient Temperature ...
key switch on, the needle on the oil pressure gauge should be either all the way high or all the way low. Grounding the wire should make the needle move to the opposite side of the gauge from where it
engine is off! What's up? Could be either a gauge gone bad, or the sending unit. Unplug the oil sending unit with key on to see what the gauge does. It's normal for oil pressure to increase with a new
...key on and engine NOT running my oil pressure guage reads HIGH oil Pressure. This is true even after changing the oil and filter. I want to change the oil sending unit but having trouble locating it. ...
Question about Cars & Trucks
...or wiring is bad. Does the gauge peg with the key on, but engine not running? An engine wont run long(maybe 10 min with no oil pressure). suspect gauge has nothing to do with a rough
1,661 questions posted
Usually answered in minutes!
1,141 Questions
504 Questions
133 Questions
44 Questions
36 Questions