...tool, the ball joints are pressed into the control arms, and a ball joint to steering knuckle seperator tool.Without those special tools, you will never get them changed, if you do it
Question about Chrysler Sebring
...change the ball joints on a 1996 jeep grand cherokee I need to know what the steps are to changing the ball joints on a 1996 jeep grand cherokee. I have the ball joints and am renting a press and ...
ball joints if they are bad change them...you posted ball joints ,,need more specifics
...change the ball joint. What are the I need to change the ball joint. What are the steps I need to do. Raise and safely support the vehicle. Place jackstands under the frame. Lower the car slightly so ...
change ball joints 2001jeep laredo 4 wheel drive if its like my 95. the only tool that would work was a large brass hammer. the 95 is pressed in. first check the auto parts stores for the correct ball
...ball joints with a built in off-set that can be used to correct that. There are a few, each having a different built in amount of offset, so you need to know how much correction you need. Camber ...
...plated? 475 would be fair. Miles have nothing to do with how good the ball joints are. they need to be checked. Alignment is critical as a height change alters front end geometry. Good ...
...change left front axle Assuming 4wd or AWD. Remove wheel. With someone in the car pressing on brakes, remove the center nut (pinion nut). I use impact gun once the retaining clips are off. Now remove ...
...shaft from the transmission to the tires. If it needs to be changed, you'll need to remove the lower ball joint & rim & tire & holddown nut to the CV joint. Hope this helps! Good
...change the inner tie rod, as the existing tie rod has place for a wrench Tie rods are replaced from ball joint to ball joint, the place for the wrench is to adjust wheel alignment toe in. Ball joints ...
1,584 questions posted
Usually answered in minutes!
1,173 Questions
801 Questions
581 Questions
462 Questions
523 Questions