...to do to replace this starter? take it to the shop You have to let the drivers side engine mount loose and jack up the motor about 3". It comes out easily this way. This is the only way to get it
...replace I can't tell you what side it's on.... but it is where the motor joins to the transmission. if it is front wheel drive (the motor is sideways). look down about the middle of the engine where ...
motor or trans mount could be the cause which allows the engine and trans assembly to shift mor to one side on a turn which changes the the axle length and lessens pressure on the CV joint causing the
...replace the ac compressor Depending on make and model , Yes and no! Most cars , the AC Compressor is mounted in a similar way to a power steering pump or alternator, loosen the belt or belts and ...
Question about Chrysler LHS
replace a belt tensioner, the only time that becomes an issue is when the bearing in the pulley fails or the tensioner is otherwise damaged. Sounds like possibly a bearing or mount is loose somewhere.
...I have a passenger had this problem. it turned out to be motor mounts. replaced them and problem solved. many shops can do this you don`t have to be robbed by the dealer. it should be under ...
replace the blower motor resistor? It's called a resistor block, you can't just change the resisitor, you have to get the block. All it is, is a small circuit board with the resistor soldered in it. I
...tube running to the gas tank for venting. I had this problem and found it by accident. After I replaced the hose the check engine light went out, Good ...
...don't loose track of those small parts.On the Melco it shows that the starter solenoid can be replaced separately, but doesn't show that for the Nipppondenso.Your Chrysler Lhs starter is
320 questions posted
Usually answered in minutes!
229 Questions
228 Questions
195 Questions
145 Questions
120 Questions