4. remove the pulley guard. 5. loosen the tensioner and take the belt off of the pulley. If you decide to replace the belt you need to remove the tensioner, remove the studs that the pulley guard came
Question about Cadillac DeVille
...4 Locate the water pump pulley. The pulley is the round part that the belt is attached to. To find it, look for the belts. You will see more than one pulley. Your car will have an alternator with a ...
...timing belt cover. Remove the water pump bolts and the pump. To install: Clean the water pump and engine block sealing surfaces. Coat the seal ring of the water pump with silicone grease, GM P/N ...
...timing belt cover. Remove the water pump bolts and the pump. To install: Clean the water pump and engine block sealing surfaces. Coat the seal ring of the water pump with silicone grease, GM P/N ...
...timing belt or chain? Are you getting power to the + positive side of the coil (small wires) with key on ? Hint; I use a needle pushed into the back of the plug so as not to damage the wiring. If you ...
...4. As for as the hood latch, right were the lever is to open the hood the regular way, is the linkage that you have to pull to open the hood. 5. Well i love cadillac but not so much the 2000 model, ...
...4 place a large catch basin under the left (driver side) of the vehicle 5 remove lower rad. at the thermostat housing CAUTION coolant will be flowing quite rapidly insure engine and coolant is ...
4 turns. On the front of the pump there are 2 bolts to be loosened, 1 on top at the engine and one on the bottom about 7 o'clock. It will be hard to spot but feel around. Push the pump into the engine
...belt that drives alt, waterpump etc, then remove the hot wire that goes to alternator. then start by removing the mounting bolts on alt, good-day ! This answer is ever so wrong and will get your car ...
1,326 questions posted
Usually answered in minutes!
1,356 Questions
1,298 Questions
1,226 Questions
1,118 Questions
938 Questions