1993 Jeep Cherokee Country "hear knocking sound car accelerate" Questions

...knocking sound you can hear is probably the big end bearings worn, these are the shells that go between the conrod and the crank shaft , it sounds like they have worn either by lack of oil at some ...

...hear the knocking with the engine on and under the hood, disconnect a sparkplug. If the knocking goes away, that is the bad bearing. Do this disconnecting/reconnecting until you identify the bad ...

...hear the knocking. It doesn't seem to do it when idle, if it does, it's not much. bad fuel damaged engine bearings rod piston crank cam timing slack timing off cam actuators etc check for trouble ...

...van 3270000 klm, well maintained, oil level fine, when start up I hear a knocking noise coming from engine? When accelerating knocking noise is louder and quicker? Sounds like a rod bearing

knocking noise car Hi, I can hear and feel a slight knock noise as soon as I accelerate from a stationary position? The knock only happens once on take off. I also did a test by keeping the car in ...

...hear a knocking noise. only when i accelerate. any ideas? CHECK ALL DRIVE BELT ACCESSORIES LIKE ALTERNATOR - AIR CONDITIONER COMPRESSOR AND CRANKSHAFT PULLEY.I HAVE SEEN A LOOSE OR BAD TRANSMISSION ...

...car for repair and they fixed my oil pan valve cover gasket and the oil pan gasket. they put the knock sensor wire direct to the knock sensor since they didnt have a connector. i drove off and check ...

...hear the knocking sound bouncing off the center divide. Please help me diagnose the problem. Any help would be greatly appreciated. Thank you in advance! Well lift the car up and put it on drive wile ...

Knocking" usually refers to the sound an engine makes when internal mechanical parts, such as piston rod bearings or connecting rod bearings, begin to wear and cause a deep "knock, knock, knock" sound

...hear a knocking noise coming from the engine. I can also hear at when accelerating. It seems to go away at higher RPM's, or else it's just not audible at higher RPM's. Any ideas/suggestions?? Thanks ...