...needed and ruins the bearing as it is a sealed unit not designed to come apart. ( to take the knuckle out take off the caliper and undo the axle nut, top and bottom ball joint and the tie rod end) ...
...tools needed, this Honda has the old type inner and outer wheel bearing's, remove cotter pin, spindle nut slide rotor out, remove wheel bearing, repack new bearing with grease and don't forget to ...
tools. Raise and safely support the vehicle with jackstands. Place the jackstands under the frame so that the front suspension hangs freely. Remove the front tire. If a silicone (gray) boot is used on
...Remove the tire and wheel with a socket wrench and disconnect the brake caliper from the caliper adapter. Slide the rotor from the axle shaft. 3 Install the new brake rotor onto the axle shaft and ...
Question about Honda Accord
remove the outer lip & all rust from all brake components & lube where necessary,that may be your only problem You do not always need to machine rotors ever year but do need to get them apart
tools needed and a little mechanical knowledge, because i dont think you can buy just the bearing at a auto parts store. they sell you the whole hub assembly which is great for the DIYer. lift the car
...rotor from the steering knuckle. Remove the nut attaching the outer tie rod to the steering knuckle. To do this, hold the tie rod end stud with a wrench while loosening and removing the nut with a ...
95 AND 96 ACCORD THE ROTORS WERE BOLTED TO HUB. ITS A JOB! U NEED A HUB REMOVER,AXLE NUT SOCKET AND METRIC TOOLS. IF U NEED STEP BY STEP I CAN CLARIFY. IT TAKES ABOUT 2-3 HOURS A SIDE DEPENDING ON HOW
2,213 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,636 Questions
1,570 Questions
1,470 Questions
