1995 Honda Accord "balance shaft" Questions

balance shaft has to set by removing the bolt in the engine block that is in line with the front of the balance shaft the get a 6mm bolt that is 100mm long slide it into the hole where you revoved the

balance shaft alinement marks on honda 2.3 litre engine set it to top dead center. there's an access hole to put a 4" or 100mm pin to keep the balance shaft from moving when replacing a timing belt. ...

...balance shaft tensioner. The balance shaft is the cogged wheel with a small timing mark dot on the side of the wheel. Next, loosen the 10mm bolt on the timing belt tensioner. It's obvious what wheel ...

...balance shaft timed right. It's easy to get it together wrong. If the timing belt is right, it'll start right up, but if the balance shaft isn't syncronized as well, the thing will shake like an old ...

replaced timing belts on a 90 accord with balencer shafts and now there is a rattle in the back of the engine. not a knock. not at idle but when you accelarate Your balancer shafts are probably not in

...balance shaft, there is a good possibility that the balance shaft seal has popped out. There is a "balance shaft seal retainer kit" available at your local dealer to fix this and prevent it from ...

...cv I have a 1995 accord it is leaking oil by the cv joint it is not transmission fluid could it be a balance shaft seal it is on the long side yes, it could be a balance shaft seal. that's

...The cam and crank mark are okay. The only one I am concerned with is for the oil pump and the balancer. I heard that to set the engine balancer I need to remove a 12mm bolt cap and insert a ...

balance shaft problem,has timing belt been changed lately this car may have a balance shaft belt and i have seen them install ouy of time and will cause a bad vibration any time engine is running hope

...the exact position they were when i pulled the belt off? oh yeah it matters...the other belt is a balancer shaft belt it runs the oil pump and balancer shaft