...Remove the wire harness fron the sending unit. Pull rubber protector back to expose the harness connecter. Clean this area good with the brush. Dirt in the tank will cause other preformance issues ...
Question about Cars & Trucks
...to take off rear seat back rest in a 92 caprice classic??? I have rear bench seat off, but need back off now. Help Should be two 13 mm bolts at the bottom. Remove them the push the seat back
...remove the two bolts on the very bottom retaing brackets then push the seal as hard as you can straight back to the rear and lift upward then you can take it out it will be very hard to push back I ...
...remove the lower bolt holding in the bottom of the rear window. Two bolts at the top are easy to see and remove. Then unplug the wires and the entire window assembly will wiggle out without any other ...
Question about Cars & Trucks
slide down. Can be difficult on some models. That's for the upper. To remove the bottom, if there are no visible bolts holding it down, you usually push in hard with knees as well and push/pull upward
remove the plastic side wall to expose it if you need access there. You can trace the wiring if needed. Under the front bottom edge of the rear seat are clips holding the seat in place. Open the clips
...bottom of the doors. What would be the cause of this? Water leaks can be really evasive, It could be coming from the rear glass where it seals against the body or it could be coming from the seams ...
Remove the rear seat bottom and seat back. Remove the partition cover. Remove the mounting bolts and remove the fuel pump set plate. Remove the three nuts and disconnect the fuel pump bracket from the
...bottom of the tank. Remove the fuel tank support strap bolts. Swing the straps away from the tank and lower the jack. Balance the tank with your other hand or have a helper assist you. The tank is ...
3,891 questions posted
Usually answered in minutes!
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions