1992 Honda Accord "obd 1 code reader 1995" Questions

...to be OBD II. It's something GM cobbled together called "GM 1." There is no code reader for this, it has to be done and some expense by a dealer, or a shop that has the appropriate

...1. Disconnect the battery, wait approximately 30 minutes, reconnect the battery. This resets the cars computer which also reset the check engine light. On newer OBD (on-board diagnostic) compliant ...

...on the OBD connector, the B pin is empty in my connector port however. How can I find out what my malfunction codes are? Both OBD 1 and 2 do not work. You need to hook it up to an expensive

...OBD 1 before that. Could be under hood. 1996 is the year that OBD II was mandated, so your Voyager might be OBD I. OBD II would have the connection under the dash on the drivers side. OBD I has the ...

obd 2 reading on 95 mustang 3.8 manual trans reads ho2s11 switching bank 1 and 2 obd 2 reads check engine light on Get a code reader device. google the code

...obd 1 or an obd 2, my engine lite is on but I get no reading from an obd 2 and a conflick of wich 2 terminals to cross for an obd 1 94 and 95 bonneville's have a odb1 system but the plug under the ...

OBD 1 (used from mid 80's to 1995) system scan tool, u can buy them on ebay The only way to get the codes from your car is with an obd2 scan tool,the good news is that they are cheeper to buy and have

... YOU CAN JUMP AN OBD-1 WITH A PAPER CLIP AND READ THE FLASHES ON YOUR DASH TROUBLE LIGHT! GO TO THIS SITE & IT EXPLAINS HOW!! ...

...OBD-1 code reader (1995 and older). Check out this video: http://www.youtube.com/watch?v=_3CzHCfz-9A If you don't have a code reader, you might just want to take it into a shop and have them tell you ...

...OBD-1 you can use a paper clip to jumper two terminals in the test plug under the dash, and then watch the check engine light  flash.  If it is OBD-2 you need a code reader or scanner. Most ...