...crank shaft turn over.? see that gross ambiguity? engines CRANK , the starter can spin fast and the crankshaft sits still. then starts (EFI does this part, spark and fuel) then sustain start called ...
need crank shaft put in and valuve cover put on engine valve cover is easy, did you have the crank shaft turned and the block linehoned? also do you have the correct bearings?
honda accord ex wont crank wont crank ...changed out motor and wont crank...could it be the cam/crank shaft or knock sensor check the wiring on the solenoid on top of your starter.and check your fuses
...crank shaft pulley. Next, remove the crankshaft pulley. Next, use a 10mm wrench and/or 10mm socket and remove the bolts holding the plastic engine side cover. Next, loosen the 14mm or 15mm bolt which ...
Question about Honda Accord
crank and cam for timing belt on 1988 honda accord 2.0 Hard to explain here... but I believe that car also has the balance shaft which needs to be timed as well. The camshaft has 2 lines which line up
...STOP WITHOUT WARNING. CRANKS BUT WILL NOT TURN OVER. AFTER IT SITS FOR A WHILE , HOURS OR OVERNIGHT, IT STARTS AGAIN. HAVE REPLACED THE FUEL PUMP AND A RELAY. try a new crank shaft positioning ...
Crank shaft positon sensor good. No spark to car. cranks over real good. replace the ignitor in the distributor check the ignition coil,cap,rotor and wires
...injector operation , the same as the crank shaft position sensor could be a loose connection that has now come apart or the sensor has finally reached a point of failure that it needs to be ...
...crank shaft machined cause the threads got shreaded, any help ill be apreciated, i live in oregon so if you know any where i can get the crank and bolt machiend that would help to thanks There are ...
3,891 questions posted
Usually answered in minutes!
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions