1992 Honda Accord "2 balance shaft timing" Questions

2 inches long to align the right balance shaft. the bolt is on the right side of the engine. there is a notch on the other shaft on the left. and a pointer on the block just to the top of the shaft...

...2 belt tension wheels. Next, LOOSEN the 10mm bolt that is on the balance shaft tensioner. The balance shaft is the cogged wheel with a small timing mark dot on the side of the wheel. Next, loosen the ...

2 off or the distributor could be off in angle, you probably will have to have the timing set with a timing light, that will cause pinging and lack of power. most times its juts needing the timing set

...2 take off your drive belts power steering and ac etc. Now lower the jack down a little and take off valve cover and power steering pump,set aside and remember were your bolts go.#3 take off timing ...

...2 belt one the t-belt that syncronize top to bottom and the outher balancer shaft belt if you have less power or engine noise the t-belt is not at the right place and engine vibration balancer shaft ...

...2 inch) Timing belt Balancer belt Bottle of Liquid Paper Disconnect the negative battery terminal. Using a ½-inch-drive ratchet and the 19 mm socket, turn the center bolt on the crankshaft so ...

...and better spent working on replacement. A typical timing belt component kit consists of: 1. Timing Belt 2. Balance Shaft Belt. 3. Timing Belt Tensioner Pulley. 4. Balance Shaft Tensioner ...

...2.0 Hard to explain here... but I believe that car also has the balance shaft which needs to be timed as well. The camshaft has 2 lines which line up to the top of the head, and a "up" or "top" mark ...

...shaft has timing marks and will line up 3 ways but only ONE is correct. a few inches behind the balancer pulley is a plug (12mm head I think) take this plug out, now insert a phillips #2 screwdriver ...

...balance shaft belt. I had the same problem. Haynes manual don't show it worth a dukey. If you put the dot on the pully straight up (look closely) you will see actually 2 little studs sticking out. ...