2002 Mercury Villager "blower fan" Questions

blower fan will only work on high speed setting this means the fans speed control resistor is burned out, when it fails the fan defaults to high speed only. The fan resistor is located next to the fan

...fan speed then you need to buy what is called a blower motor resistor. You might be able to get one from your local parts store. I don't think that is a dealer item because of the age of the car. But ...

...map) for the heater and blower fan fuses. If you don't have an ohmmeter to test it, your local Autozone will test it for free, which is convenient since you are likely headed there for the new

...the blower motor so it doesn't turn at full speed when you have it set to fan speed 1. When the resistors blow out the only setting that works is full speed because it doesn't go through the

...blower motor is powered up. Supply a ground to the other wire and the fan should blow. If this is the case, I will bet the farm that you need to replace the sliding lever control for the rear fan on ...

...blower fan does not start working until you turn it to (speed) 4. What could the problem be? The most likely cause is the blower motor resistor. It is a common failure with all autos. It is mounted ...

front blower motor got the blower motor out of vehicle cant get the fan off the blower motor Should b a C clip on the end of the shaft use a flat head and some needle knose

...blower fan moduel is it hard to get to It is under the dash behind the glove box. It is not real hard. Remove the glove box, remove the lower instrument panel brace, remove the heater motor/A/C hose, ...

...If no current then the switch is bad, or the relay is bad. Obviously check your fuse as well. Could also be your blower motor resistor if the fan only works on high speed on not the lower

...fan switch only works on high it's your blower motor resistor in the plenum case. They usually blow the thermal limiter because the blower motor is drawing too much current. It's starting to go. You ...