1995 Mercury Villager "rpm" Questions

hard to start, engine dies on higher rpm Hard to start and stall at higher RPM. So you are stalling at load. What the engine needs at higher RPM and load is more fuel.The fuel pressure at idle ...

high rpm shifting the van is having trouble shifting. the van reaches high rpm before it will shift. any help Does your van have an "EAT" switch -- lower right hand side of instrument panel? Pressing ...

...to the normal operating temperature. Turn off all electrical loads. Rev the engine to 2000-3000 rpm two or three times and allow the engine to return to the idle. Turn off the engine and ...

...with another one. I am having trouble with the car shifting into 2nd and 3rd hard at 3500 rpm. O.d kicks in at 4500 rpm. No problem down shifting. note: tranny fluid leaked out of the shaft ...

...cap is higher than the heater core. The remove radiator cap and run engine until warm then hold rpm to about 1200 rpm's and top off coolant level until you have no more

...Catalytic converter. Now as far as running it "forever", you want highway speeds, which in terms of RPM is about 2000 RPM on many vehicles. You can shift out of "overdrive" and this will keep the RPM ...

...at wal mart. more recently my engine started revving with the car in park 9going from the normal 1 RPM to about 1.5 RPM. just last night the engine light came on for the first time of this whole ...

I think it is my modulator, shifts only ay high RPM.. where is it located? front wheel drive I have change filter and fluid still haveing problems tp sensor bad or out of adjustment ...

I have a 1995 Mercury Villager that misses while accelerating at low rpm. What are some possible causes? clean MAF sensor with carb cleaner. do not touch the 2 wires you just spray them. http://groups

1993 Mercury Vilager when hot the idle speed go to 1800 rpm and vhile drivig with stop an go there is hollow soud of engine go here for expert help gerry http://groups.yahoo.com/group/villagerquest/