1995 Honda Odyssey "square mm wire needs 1" Questions

...square block, being sure that the black silicone gasket on the bottom of the round plastic washer does not get bound up on the engine post where the 10 mm bolt goes. Tighten the bolt17. replace the ...

...square of the tensioner & pull towards the front of the car to release the serpentine belt 4) lock tensioner with about a 4mm pin(Allen key will do) by pulling forward with that 1/2"drive ...

...mm crank pulley bolts. 8.Remove all three belts. 9.Remove oil filter and you might as well drain the oil too. 10.Remove crank pulley. 11.Remove upper (1 center nut) and lower (2 side bolts) harmonic ...

...square against the timing chain and against the timing cover center bolt. The narrow ramp of the wedge tool needs to be placed so that it faces the timing chain. The wedge tool should be lightly ...

...mm bolt and the relay is a four prong square box bolted on the framewith two 8mm bolts www.autozone.com Click component location. Some are located under the drivers side headlight, Removeair cleaner ...

...mm closed-end crescent wrench. Length should be no longer than 7 inches. Installation: pop the hood, and remove the plastic engine cover. I assume you know how to remove the front plugs. So I'll only ...

...mm head bolt. Remove the bolt and bracket. 3) You will see a large round cover; this is where the low beam bulb is located. Remove the cover by turning it right/clockwise (as viewed from the ...

...mm socket. Next you will need a good spark plug socket, (5/8 in, I think) a 3/8 ratchet, and perhaps a 10 in extension bar with a 3/8 square drive on the end. Take only the socket attached to the ...

mm bolts hold it in place. Remove the marked plug wires from the pack, unplug the two wire connectors. I worked the pack out from underneath the care. There is a crank sensor on the back of the unit -