1986 Honda Accord "level 86" Questions

...86 GMC Suburban? I've found the oil fill location and the power steering fluid location, but I don't see the transmission fill location. get a funnel and pour it into the dip stick hole that you use ...

86 did You have to have it aligned after you replace them, with struts You won't have obd 1 software, to command them up & down & you would have to make a fitting to put on the shock/ strut to

86° to 130° F (30° to 55° C) before checking With engine running, switch on AC While holding vehicle with brakes, place transmission into each gear briefly With engine running and transmission in park

86 f150 runs fine until hot then acts like running out of fuel Had same problem.Floats in carby where sticking and flooding second stage. Cleaned and reset levels.

86 bronco2 4by lost drive in all gears with no warning have drained and replaced filter checked all fluid levels could it be torque convert ? sure your driveshaft didnt snap off?

the 86 bronco II to start and run but will not go when put into drive or reverse? Check your Transmission Fluid. If it is low fill to the recommended level. If it smells burnt it is time for a Rebuild

86 time period (mostly 1984) & were powered by 6.2L Detroit Diesel V8 engine. ... Many M1028s were upgraded at the company level to M1028A2 and A3 specs. ... rated at 155 hp (116 kW) and 240 lb·ft

...level of the shift rails or at the bottom of the gear lever at the top of the box. pin 86 goes the heat sensing switch in the rad....pin 86 to one pin on the switch and the other pin to ground! Hope ...

...level sending unit and wont do any good for an in tank fuel pump either . if you have a standard carburetor, this problem can be caused not only by water, but by dirt,or rust particles plugging the ...

86 f150 dual tank the guage is not registering on both with tanks full clibrate the fuel sender lever with the gague level