1996 Subaru Legacy "ignition system" Questions

...ignition coil unit) to two cylinders that are in the same position but 180 degrees out of phase in firing, the system can turn on and off two spark coils twice as fast with half the electronics and ...

system. To enter this mode connect the test mode connector with the ignition ON . On the Legacy and SVX, the ignition must be ON with the engine running. F-Check Mode : used to measure the performance

...ignition but dont start motor. The check engine ligth will flash, the flash long are numbers 10, the flash short are numbers 1. Example: the check engine ligth flash long 2 times, the code is 20 or ...

ignition ON. D Mode: used to diagnose and test the entire injection system. To enter this mode connect the test mode connector with the ignition ON. On the Legacy and SVX, the ignition must be ON with

...On the end of the wire is a small button. Push the button with the ignition in the on position. It will reset the alarm system. That will stop your lights from flashing. Have a great day. ...

...ignition the running lightsremain on and the dash lights continue to flash with a clicking noise. When I turn the lights on the flashingstops but the clicking noise does not. The whole time the ...

...ignition control module & battery & terminals. Called tech at Subaru he's stumped. Sounds like weak connection somewhere,I would start by one at a time,clean by scraping the prongs of each fuse. If ...

...system. Unlock vehicle with the key or turn ignition switch to ACC or RUN position during 30 seconds after remove the key, Unlock the vehicle with the key. and alarm has to be diasarm. Remenber ...

...system the check engine may not light unless the PCM (powertrain control module) sensed a rich or lean mixture via the oxygen sensor. Does the check engine light turn on with the ignition key on ...

...and drive for a while and the same thing happens, any ideas? check plugs, wires, etc. check all ignition ...