what cylinder in the timing in line with on a what cylinder is used to find dead centre on the pully of a subaru legacy 1998 is it cylinder 1 or 4 Cylinder number 1 on a compression stroke.
COULD YOU PLEASE TELL ME WHAT IS TIMING SET UP &WHICH CYLINDER IS NUMBER 1 Cylinder #1 is the front cylinder on the passenger side. The firing order is 1-3-4-2. Cylinders 1 and 3 are on the ...
my book says 137 lbs is the low number for compression. we thought that the cylinder leaked a little during the process. I am still stuck on the air fuel ratio. I think it is flooding with a rich ...
...TO RUNNING ROUGH W/CHECK ENGINE ON. CHANGED MASS AIR SENSOR, KNOCK SENSOR, COIL PACK(SPARK TO ALL CYLINDERS), SPARK PLUGS, RAN "SEA FOAM" THROUGH ENGINE. CODES SAY #4 INJECTOR. WHICH CYLINDER IS
...it. Hope helps; keep us updated. That is too wide of a gap between cylinder compression readings. 190 psi is great and 120 is worn but workable. What were all of the numbers and which
...numbers off on the timing plate or front cover. Hi: I have not done a timing belt on a Subaru Legacy, but on all of the other ones that I have done, it is really important to put the engine in the ...
...all 4 wires reads 11 amps from module to all four plugs. Read-out say's problem with number 4 cylinder. Re-set is good for a few days? I would have the coil tested again. May have a bad ground. ...
...spark-plugs, and every thing alse, issue number one was that when i timed the car up to t.d.c on cylinder 1 firing, the cam shaft marks did not line up no matter how many times I checked and tried ...
car will not start car is a 1991 subaru legacy, which was running on three cylinders so gave it a compression test, number two cylinder had no compression, so gave it a valve grind and put back ...
522 questions posted
Usually answered in minutes!
447 Questions
411 Questions
317 Questions
328 Questions
291 Questions