head bolts/studs, manifold gaskets, timing belt, timing tensioner, accessory belts, water pump, thermostat, all fluids (since they'll be drained before starting), etc etc etc). It's a huge job and one
i need head torque specs on a 2000 xterra Cylinder Head Bolt step1 22Ft Lbs- Step 2 59ft Lbs- Step3 Loosen All Bolts- Step 4 22Ft lbs- Step5 86-91 degress.Thanks
...head bolts for a 1985 ltd 3.8 thank you Six IN LINE - 6L Fig.: Cylinder head torque sequence - 6 -cylinder engine Cylinder head torquing should proceed in three steps and in the prescribed order. ...
...head bolts and rod caps on a 1999 nissan altima with a 2.4l engine Rod cap nut's Step 1 -10-12 Ft.LBS Step 2 - 60-65 Additional Degrees Head Bolt's Step 1 - 22 Ft.LBS Step 2 - 59 Ft.LBS Step 3 - ...
need torque spec. for 91 honda crx head bolts 47 FT LBS TORQUE.is for the 1.5 and 1.6 engines 2.2 is 78 ft lbs and the 2.0 -2.1 is 49 ft lbs. the crx engine is 47 ft lbs
what is the torque specs for the head on a 91 toyota 22r motor cylinder head bolts 58 ft-lbs
...head gasket issue. I would get a valve grind kit instead of just trying to torque it down more as it may not be a problem of the bolts being at different torques. The values will need to be looked up ...
Question about Subaru Legacy
what are the torque spec for crank to flywheel on a 91 capri xr2 look at size of shank of the bolt ? dont forget some locktite .if around 15mm head size then around 60lbs
...head bolts finger-tight. On all models except 1988-89 DOHC Prelude and 1992-95 Preludes with 2.3L and VTEC engines, tighten the head bolts following sequence A. On 1988-89 DOHC Preludes, use sequence ...
338 questions posted
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
317 Questions
328 Questions