1994 Jeep Cherokee Country "changed fuel pump gauge stuck" Questions

...fuel pump the fuel pump and sending unit are both in the tank they should be replace at the same time most chy pumps are sold as a pump and module you should take it back to the repair shop  ...

...fuel pump from a cupple phone calls and was told the filter i dont want to get stuck somewhere or get ripped off what is the problem and how much sould i pay? thank you for you time. The Pump and ...

...but cant guarantee its any good after being stuck My truck is a 96 silverado k1500 Z71 , fuel guage is pegged past full mark , i replaced the fuel pump and sending unit but nothing changed on the ...

...fuel gauge fluctuates. changed pump & sending unit. now gauge stuck on E. changed unit again in case defective same problem but not same as original problem Gauge is likely burning out on you. Also, ...

...fuel pump in my 2005 Chrysler Pacifica and and my fuel gauge still shows empty it work for a little while showed how much was in the tank know I'm trying to see where to go from here whether it's the ...

...changed the fuel pump on my 89 chevy pickup and the fuel gauge stays on 1 quarter tank all the time what is the problem? The fuel gauge in the fuel tank is simply a float connected to a bar connected ...

...changed my fuel pump on my 1997 ford explorer and now the gas guage will not work, and the warning light that says check gauge is on the wires to the fuel pump are defective and not making proper ...

...changed the fuel pump several time thinkn it would fix the problem but i didnt. i need a picture or sumthing to show me how to fix the guage or any suggestions.. You could try changeing the fuel pump ...

...and then stays there. this is most likely caused by the sensor thay is locaed inside the fuel tank itself. usually when a fuel pump is changed , so is the sensor as it is attached with the new

changed the fuel pump and the gas gauge is still stuck of full. WELL IT IS A SIMPLE CIRCUIT MOST ARE BLOW FUSE BAD WIRING TANK SENDER DEAD. RARE BAD METER. did you first SCAN the PCM to see what is up