1998 Honda Prelude "normal resistance crankshaft sensor" Questions

...resistance but the normal is 1 - 3.2... for twice... is it a poor connection wire , broken wire.... starting the connector to ecm? heres adiagram to check resistance of the sensor, it should ...

...resistance readings on coil are good. Readings on crankshaft position sensor are normal. Jeep shuts off as if being turned off. the egr valve is closed when the engine is cold. when the engine is ...

...normal. Verify that there is no power or ground problem to the crankshaft sensor, the Yellow/Black wire should have battery voltage any time the key is on and the main relay is energized.Verify that ...

...normal act almost like a fuel pump going bad more than likely that it is either ba crankshaft position sensor if it has one or ignition module because they build resistance when the copper windings ...

normal running engine with the engine being diagnosed. (1) ECT Electrical Connector (2) Connector Tab (3) Engine Coolant Temperature (ECT) Sensor The engine coolant temperature sensor is a thermistor

...normal. If the signal received from rear (#2) O2 sensor indicates that the voltage has "stuck" between .425V to .474 V, the PCM determines this sensor is inactive and this code will set. Potential ...

...normal but will not start. No codes being set. WILL start with starter fluid sprayed into upper intake, so it will run. Apparently, no fuel being delivered to injectors, but, Fuel pressure at fuel ...

...resistance and short internally when hot but work normally when cool. Might also have a bit of a weak spark as a result of a bad coil. Crankshaft position sensor. Instead of keep on guessing run a ...

...resistance values are within parameters.changed spark plugs, checked wiring ,plug connectors etc." no bus" read out on inst cluster . hooked scanner to obd 2 port and got a "no link" reading. also ...

...normal, substitute with a known good CMPS sensor and check for proper operation. If the problem is corrected replace the CMPS. 2.5L Engines Disconnect the sensor electrical connector. Connect an ...