1997 Honda Prelude "tools need replace clutch" Questions

...need to be able to read all powertrain systems, not just engine data. If it has a specific code for, say one of the shift solenoids, or the linear solenoid, you may be able to replace parts/fluid and ...

...tools you need EN 48543 FAN CLUTCH HOLDING TOOL. J41240 FAN CLUTCH REMOVER AND INSTALLER. TORQUE FOR FAN CLUTCH NUT 41 LB FT. FOUR BOLTS TO FAN BLADE TORQUE 20 LB FT.WATER PUMP BOLTS TORQUE TO 11 LB ...

...clutch assembly you will need to have the small tool kit that comes with both tools for pulling and installing clutch assembly. Check with Autozone and see if they have it in their tool loan

...tools to do that You'll need a jack to hold the transfer case once you remove all the bolts holding it to the transmission. Remove the drive shafts.Then you'll need to remove the transmission, again ...

...need to replace the entire a/c unit or the clutch assembly or what? THE ELECTRICAL TERMINALS ON AC CLUTCH COIL IS BROKEN OR DAMAGED THE CLUTCH COIL HAS TO BE REPLACED.YOU DONT HAVE TO REPLACE THE ...

need some snap ring pliars, a hub removal tool, and some patience. the parts and tools are available at most any local parts house, the new clutch should come with instructions, if not a repair manual

need to replace the compressor or can I replace just the clutch? And where can I find instructions on how to replace the clutch? Thanks. You can replace just the clutch. You will need a special puller

...tools am I need to replace clutch kit for vw micro bus 2.5i normal range of spanners and sockets The tool that will make the job easy will be a clutch aligner tool ( auto spares shops) make sure that ...

after replacment clutch set both cylinders still pedal on the floor U need to vacuum bleed the clutch, buy a tool called a "MITYVAC" brand Vacuum clutch bleeder tool

...tools required? install new clutch, new clutch master cylinder bleed real well all new parts and still unable to put in gear clutch peddel real soft no pressure at all. what i'm I doing wrong? ...