1997 Honda Accord "set pulley system" Questions

pulley, timing belt cover, set engine at TDC #1 (align marks), remove nut on tensioner shaft to loosen both belts, remove the belts and tensioners (replace all), replace water pump NOW, install timing

...set to full on and coldest setting, see if the center of the pulley on the compressor is turning or is just the outside edge where the belt runs turning while the center stays still. In the center is ...

...set the timming on a 95 honda accord 1990?95 4-Cylinder Accord and 1992?95 Prelude . Fig. 10: On all engines except VTEC, the belt adjuster arm must be locked in place using one of the lower cover ...

set cylinder No. 1 to TDC on the compression stroke. Once in this position, the engine must NOT be turned or disturbed. On DOHC Preludes without VTEC, hold each of the camshafts in the TDC position by

...pulley and bolt, tighten the bolt to 181 ft. lbs. (245 Nm). Rotate the crankshaft sprocket 5-6 turns to position the timing belt on the sprockets. Set the No. 1 cylinder to TDC and loosen the timing ...

Pulley Puller set (to remove and attach the pulley). Some auto parts stores will loan the tool sets.Socket set.Open end wrench set (for use with puller set).Leverage pipe or extension bar (in case the

...set pin of the auto tensioner. Install the upper and lower timing belt covers. Install the power steering pump pulley, idler pulley, tensioner pulley and crankshaft pulley. Using the wrench [16mm], ...

...pulley 303-588 Remover, crankshaft seal 303-D121 Installer, crankshaft seal 303-1100 Adapter - Crankshaft seal installer 303-1100-01 Removal Disconnect the battery ground cable. For additional ...

...to fully lace the belt without moving the pulley out fo the way. You might have a second set of hands to help hold the belt. The first time is the hardest. Good luck and let me know if all went

...set Torque wrench Pry bar Park your Range Rover in a safe place, open the hood and disconnect the black, negative battery cable. Locate the drive-belt tensioner pulley (this pulley does not drive any ...