...the wires corrode, and fall off, which would make it click and not start. also, check all of your fuses, !!GOOD LUCK!! ...
Question about Honda Accord
...fuse or wiring also. Check grounds. Both could be a bad ground. D4 Blinking usually indicates transmission issues, but it can also be triggered by issues with the ECU or Main Relay, which would ...
...light glows brightly, you have a short somewhere. Now, with the light still glowing, start removing fuses one at a time until the light goes out. The short is on a circuit that is protected by the ...
...prevent it from working properly. Probably need to take the clamps off the post and wipe it out/off, the rub it with some fine sand paper. All connections should be good, clean metal to metal. If ...
...prevent stalling, and then let the idle stabilize. In regards to the relay you mentioned I believe that its either in the cars fuse block panel inside by your feet on drivers side, and in the engine ...
...starting. First, if the engine won't even crank over when you turn the ignition to START, your car obviously won't start. When you turn the ignition key to start your car, voltage from the battery ...
Question about Honda Accord
prevent spark from getting to the plugs. The distributor cap is easy to replace (keep those plug wires in order!), but the rotor button can be a pain because it is held on by a small screw that's hard
...starting. If it now starts, try running some good injector cleaner through the car for a couple of fill ups; It could be that an injector is leaking and floods the engine periodically. Injector ...
...fuse 2 and 28 are good? Can you check for voltage at the fuel pump connector using a test light? Maybe the problem is with the wire that goes from the relay to the pump. That is the only thing I can ...
2,332 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,570 Questions
1,470 Questions