1993 Honda Accord "pull flash drive computer" Questions

...Pull down the carpet to see the diagnostic light. Turn on the key to count the flashes to get the code. Pulll a list of codes from the internet. If your trans shifts properly if you manually shift it ...

...was going out i drove most of the way home but it went completely out b4 i got here i got pulled home. i replaced the distributor no fire to the plugs so i thought the coil might have went ...

...computer has stored a code, that will give you some idea where to look for the problem. Here is a link describing how to retrieve the codes. Good luck. ...

...computer can drive you crazy.92 is pre OBD 2 or OBD anything,codes are pulled from the car manually.Passenger side interior,front kick panel.Remove the kick panel,locate BLUE colored TWO WIRE ...

...flash and the car would not have no pep as liong as it flashed recently the light is staying on consistently and the car has no pep at all do you have any idea at all what this could be Hello, I have ...

...pull when this 15 code comes up and hold it out of fuel box for 10 seconds and then put it back in. This reset the computer and then it showed no code, (no flashing light.) He told me to drive it for ...

flash when you turn key on. He told me to check it once home, I did, and the 15 flashes (code 15) is back and what this means is I need a speed control sensor. And he said it definitely does whack out

pull over and let it idle below 1000rpms, Light will keep Flashing.. But if we reve it above 1200 rpms. the Light will quit Flashing, and turn off, till start driving again... 2001 beetle Visit the on

...drive.it skips real bad.want pull off...it shows on computer.camshaft sensor and 14 other codes All so it has over drive light flashing..and i hear a lot of air.like in driver You have 14 ...

...pull over and stop driving, you are damaging your engine. I would take it back to whomever did the work immediately Got to see wich cylinder is misfiring get it scan when the light flash its to warn ...