1993 Honda Accord "fluid level sensor" Questions

...fluid level sensor is usually not hard to find (follow where the wires are hooked up). The best solution is to replace the sensor. Take a look at the wires and look to make sure nothing is caught on ...

fluid level (on the brake master cylinder under the hood) to monitor the level of the fluid in the reservoir 3; brake pressure sensor (on the brake dispencer under hood) will warn you in case of brake

...bad sometimes and often, and also low power steering fluid can effect their readings. Check your power steering fluid level and see if that is the cause, If not, the sensor is probably worn out a

...fluid level in the ABS unit (see pic, similar, I think). It should be between the max and min levels indicated on the front face of the reservoir. You should also check your regulator brake fluid ...

...the car is runung how can i fix break light is on dashboard when car is runing Check your break fluid level. When the fluid gets below the sensor, the dash board break light will come on and stay

...fluid level make sure its full it could also be your transmission filter It may be dirty if there is alot of miles on it. there are quite a few things that could cause it from vacume lines to sensors ...

fluid level - Dirty transmission fluid - Faulty shifting solenoid valve - Shifting solenoid valve harness or connectors - Shifting solenoid valve circuit is open or shorted The Error code is generally

...level of fluid in it when I had it serviced by them and I had drove it this way for a total of 6 weeks after the exhaust o2 swap and tranny fluid change. The Honda dealer found two codes, o2 sensor ...

...level fluid and test engine temperature sensor; sometimes, when PCM detected this warning signal from ECT (Engine Cooling Temprature) sensor, the engine wont start i order to prevent some damage.Hope ...

...fluid level correct...first check the brake pads then the disks and clean the sensors with an old toothbrush and reseat, also check the fluid level on the abs system.this should clear warning ...