...1/2 inch drive ratchet 10 mm wrench 12 mm wrench 10 mm socket (3/8 inch) 14 mm socket (3/8 inch) 17 mm socket (1/2 inch) 19 mm socket (1/2 inch) Timing belt Balancer belt Bottle of Liquid Paper ...
1. Purchase a wrench for spark plugs 2. pull the tension wires from engine. 3. insert the wrench until wrench gets a grip of spark plug 4. turn until plugs are completely loose 5. do this for the rest
1. Remove the round plug near the rear center of the headliner. 2. Insert the moonroof wrench (from the tool kit, should be in the trunk) into the socket. 3.Turn the wrench until the moonroof seats in
...1 You should have 2 o2 sensors.... Your 1st should be bolted onto your exhaust manifold (headers)on the side. You should be able to see it easily when you open your hood. The secondary O2 sensor ...
1.) Unbuckle the rear seat belts. 2.) Locate the bolt in the center part of the rear seat, between the cushion and the seat-back. Remove the bolt with a 6 mm socket wrench. 3.) Push down firmly on the
1/2 turn and STOP. These are the 2 main reasons for your dilemna now. No lubrication and too tight. Once you finish, start the engine and check for leaks. If the filter is leaking then give it a small
What is B1 and 15% mean on the Honda Accord 2008 Also has an orange wrench light Please explain in detail Bank #1 15% Fuel Trim ???
...wrench. I broke a half inch breaker bar trying to get it offf) next use puller to take off crankshaft pulley.support motor and remove motor mount bracket. take off upper and lower timing belt ...
...1. You need to replace the temperature-sending unit, also. 2. Use a 17-mm deep socket and wrench to unscrew the temperature-sending unit. It is located to the right of the thermostat housing with ...
3,428 questions posted
Usually answered in minutes!
2,998 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions