Question about Honda Accord
...3000 rpms, had the valves adjusted and that didn't solve the noise you check clearance cam shaft.if your cam shaft big clearance.you need fix clearance.the noised your engine or valve any particular ...
...Valve is out of adjustment. This valve is located ot the front of the intake manifold on the driver's side just below the accelerator cable. To adjust it, wait until the engine is cold (best to do it ...
...3000 rmp. If you floor the pedle in idle , the car dies. If you. Try and do a powe breake, the car dies. The car will not go over 25 mph. I have replaced the spark plugs, wires, cap, rotor, idle air ...
...valve. Although I found a replacement part online (70 bucks), I jury rigged the choke by disconnecting the diaphragm control arm from the choke butter fly, and wired the butterfly completely open ...
...3000 when started cold then it should settle to 750 to 1000 after about 30 to 60 seconds. mine suffers a similar problem. so far I have been told various answers, mostly involving the bac valve, ...
...second - engine RPM stays same - go to third & third appears to engage. What's my problem? Maybe the shift valve in the valve body is sticking, or shifter adjustment? Might be wise to contact
...valve .accilerat up to 3000 RPM check rad if move .if not check vacum hose if no vacum check valve if ok .if the vacum ok check rad you can move in and out if no open turbo side and clean the valve . ...
...valve clearance,if not try every 3000 miles to do the same flush way I recommend. It will work unless is a long time working with the tap noise where surely caused damage . Good Luck and let me know ...
...valve for my greddy stage 3 turbo on my 87 Toyota pickup. How do I adjust the wastegate so it didn't release at 3000 rpms hi is this pick up diesel if it is this is a safety point and the boost is ...
3,428 questions posted
Usually answered in minutes!
2,998 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions