1991 Honda Accord "set balance shafts" Questions

balance shaft alinement marks on honda 2.3 litre engine set it to top dead center. there's an access hole to put a 4" or 100mm pin to keep the balance shaft from moving when replacing a timing belt. ...

I am trying to set the timing mark on a 1996 honda accord with a 2.2L 16 valve. The cam and crank mark are okay. The only one I am concerned with is for the oil pump and the balancer. I heard that to ...

balance shaft has to set by removing the bolt in the engine block that is in line with the front of the balance shaft the get a 6mm bolt that is 100mm long slide it into the hole where you revoved the

...set aside and remember were your bolts go.#3 take off timing cover 10 mm bolts all around the out side of the cover take top off out the top and put a 3/4 socket on a impact and take the bolt out of ...

...tooth or 2 off or the distributor could be off in angle, you probably will have to have the timing set with a timing light, that will cause pinging and lack of power. most times its juts needing the ...

how do I replace oil pump on 95 accord Write down the radio security code and the radio presets on your Honda Accord then disconnect the battery cable. Place the number one piston to TDC and remove ...

...belt drive pulley, timing belt pulleys and upper/lower timing cover prior to belt installation. Set timing belt drive pulley to TDC by aligning dimple on pulley with dimple on oil pump. Set ...

...set cylinder No. 1 to Top Dead Center (TDC). The white mark on the crankshaft sprocket should align with the pointer on the timing belt cover. The words UP embossed on the camshaft sprocket should be ...

...balance shaft just to the left and a bit higher than it (marks on the cover line up each with the mentioned shafts). If you know that those bottom pulleys are then in the correct positions on their ...

...set marks well(ensure that this balance shaft is on the correct rotation and align) And remember as you hand crank the engine around two full turns to check for all marks to align again.The engine ...