1991 Honda Accord "cable install throttle" Questions

Ad

...it to see if it is holding the throttle open when connected. if this is the case, you may need to adjust it or find a slightly longer cable. check any adjustments on carb, adjust throttle

Ad

Question about Honda Accord

1 Answer

cable at the throttle body.Connect the fuel lines.Install the brake booster, PCV and charcoal canister vacuum hoses.Install the air cleaner and intake duct.Refill the engine coolant. It is recommended

Ad

Question about Honda Accord

2 Answers

...cable at the throttle body. Connect the fuel lines. Install the brake booster, PCV and charcoal canister vacuum hoses. Install the air cleaner and intake duct. Refill the engine coolant. It is ...

Question about Honda Accord

1 Answer

...throttle cable to determine the accelerator opening value when the driver presses the accelerator pedal. The accelerator pedal opening value is converted to a signal in APP sensors A and B and ...

Question about Honda Accord

1 Answer

cable during this exhaust and o2 swap). The following day I had my car tranny fluid and new muffler installed by Honda dealer. The car drove fine for two weeks but I only live 1.5 miles from my job so

Question about Honda Accord

1 Answer

cable at the throttle body or carburetor. On automatic transaxle vehicles, also disconnect the throttle control cable. Disconnect and tag all the wire harnesses and vacuum hoses from the cylinder head

...install a fuel pressure test gauge. Reconnect the battery ground cable and proceed to start the engine and allow the system pressure to stabilize. While the engine is at idle, block off/pinch the ...

Question about Honda Accord

4 Answers

...throttle linkage and set the engine speed at 2,500 rpm. Let the engine run for about 20 minutes with the hood shut. Then remove the wire and turn the engine off. Let it sit for five to 10 minutes. ...

Question about Honda Accord

1 Answer

...in.lbs. (3Nm). The PCV valve fresh air tube. The fuel injector sight shield. Torque the nuts to 20 in.lbs. (2.3 Nm). Install the negative battery cable. Pressurize the fuel system and verify no

cable. Install the air intake tube. Connect the breather hose to the valve cover. Connect the IAT sensor connector. Connect the negative battery cable. Fill the cooling system i hope this helps tps is

Not finding what you are looking for?
1991 Honda Accord Logo

3,428 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,998 Questions

1995 Honda Accord
1995 Honda Accord

1,631 Questions

1996 Honda Accord
1996 Honda Accord

1,636 Questions

1998 Honda Accord
1998 Honda Accord

1,570 Questions

1994 Honda Accord
1994 Honda Accord

1,470 Questions

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...